Static load weighing module HT-FW/FWC weighing module installation requirements

HT-FW/FWC weighing module installation requirements:

1.The flatness of the installation foundation of each weighing module should be within 0.3mm.

2.The foundation of each module should be in the same horizontal plane, and the plane requirement is between 0.3mm.

3. The flatness of the supporting surface connected to the weighing module should be within 0.3mm.

4. Each supporting surface should be in the same horizontal plane, and its plane requirement is between 0.3mm.

5.The installation position of semi-floating modules should be as far away as possible from fixed modules.

    Three weighing modules are installed with an angle of 120°.

    Four weighing modules are installed, and the fixed module is installed, and the semi-floating module is installed on the diagonal.

6. The connection between the module and the foundation and supporting surface can be bolted or welded. If it is welding, pay attention to the grounding of the welding machine.

When the module bottom plate is welded to the foundation, the welder should be grounded on the foundation, and when the module is welded to the support surface, the welder should be grounded on the support surface.

Remember: Do not pass current through the sensor to avoid damage to the sensor